1. Attention
Before installing, the static electricity of the body should be released first, in order to prevent all kinds of semiconductor components in the components of the electrostatic discharge breakdown circuit.
Before installing, read the instructions of various components, especially the motherboard instructions, and set the jumper properly according to the type of CPU.
All power interfaces, especially the power plug connected to the power supply, must be checked to see if there is a reverse connection or loose. In particular, the reverse connection of the power supply, once the power, often will immediately burn the connection of the equipment.
Check of memory and adapter card. The spring in the new expansion slot of the computer …show more content…
Setup script 1. Install CPU First of all, look for the right direction. Observe the CPU slot on the motherboard and align the slots in the CPU slot. When installing the CPU, you should gently pull the slider next to the CPU slot gently 90 degrees, at this time CPU can be slightly damped into the CPU slot, and then put down the slider to fix CPU.
2. Install CPU fan The armless head on a CPU slot, and then press the CPU CPU fan cover, the other end of the arm, the other end of the buckle slot CPU. Connect the CPU fan to the power supply. Otherwise, a few seconds will make the CPU overheat and burn down.( If the need to purchase another fan in CPU coated with silicone grease)
3.Install memory Aligning the bump on the memory and memory slots, press left / right respectively, hear a whisper Bang ", left / right card will automatically buckle, and then use the same method of pressure on the other side can be good. 4. Internal installation of computer …show more content…
Then install the bezel attached to the motherboard accessories, Finally, it is a good 6 or 9 cylinder screws, fixed board. The hard disk can choose the cabin space to install, the general principle is by the middle, guarantees the more place heat dissipation, four screws. Remove the case bezel, plug in the PCI-E slot, and then screw on. If there are multiple PCI-E X16 slots in the motherboard (the longest one), the priority is attached to the one near the CPU end, so that the graphics card is running at full speed(1080ti is a big one so need to be careful). The power will be placed in the chassis power supply, installation must make the fan facing the inside of the box, so that it is conducive to heat dissipation. Finally, fix the screw. The power line from the back of the outlet through, after the next line from the two into the box, when entering, according to the motherboard socket position and hard disk fixed position to select the entrance line. Finally, according to the chassis, the power motherboard position to install a variety of lines, the box inside a variety of cables for simple finishing, in order to provide good cooling