Free Essay

Doc, Docv, Pdf

In: Computers and Technology

Submitted By 09283971140
Words 293
Pages 2
YURI, JON III-BSIT JUNE 30, 2015

IDENTIFY ONE DEVICE * DETERMINES THE OBJECT/MODULES THAT CONSTITUTE TO IT. * LIST DOWN THE ATTRIBUTES AND METHODS (FUNCTION) OF EACH OBJECT.

BLENDER 1. BLENDER JAR * This is the receptacle into the ingredients are placed. The blender jar sits snugly or locks in place on top of the main base which houses the motor and blade assembly. The bottom of the blender jar is open to allow the blade access to do its job. Though many blender jars are made of glass they can also be plastic and metal.

2. BLENDER JAR LID * The jar lid covers the top of the blender jar allowing you to safely operate the blender without your ingredients exploding from the jar.

3. JAR LID CENTER CAP * The center cap is that small plastic thing found in the center of the lid. It helps to keep liquids in but also allows you to add ingredients easily.

4. BLENDER BLADE CUTTER * The blender blade cutter is the stainless steel blade that does all of the crushing, stirring, pureeing and anything else your blender functions do. 5. O RING SEAL * This is a flat piece of rubber that sits between the blender blade cutter and blender jar. It creates a seal so that food particles and moisture do not get inside the motor and cause damage. 6. BOTTOM SCREW CUP * The bottom screw cap is important to the proper functioning of a blender. The bottom screw cap is what holds the blender blade cutter in place during operation. 7. BLENDER RUBBER DRIVE CLUTCH * Made out of rubber; this rests on top of the motor and on the bottom of the blade assembly. 8. MOTOR * This is hidden in the base of the blender.

Similar Documents