Week 4 1. What is the production system that supports conservation and renewal of resources? a. Sustainability 2. What includes: resources, recycle, regulations and reputation? b. The four R’s sustainability 3. This type of decision is a choice between producing a component or a service and purchasing it from an outside source? c. Make-or-buy decision 4. Maximum output of a system in a given period is? d. Design Capacity 5. The number of units at which the total revenue = total costs is? e. The break-even point 6. Transportation costs/Building Rental Costs/Direct Labor Costs/Raw Materials: Which cost would not be incurred if no units are produced? f. Transportation/Direct/Raw 7. Which of the four represents break-even-analysis? NONE OF THE ABOVE g. Costs & Revenue are not shown as a straight line/ Neither costs and revenues are made up of fixed or variable portions/ Cost decreased in direct proportion to the volume of production while revenues increased at a decreasing rate of production volume/ revenues decrease in direct proportion to the volume of production while cost increase at decreasing rate of production volume. 8. The actual output as a percentage of design capacity is? h. Utilization 9. What are costs that will be the same month after month within a relative period of time? i. Fixed Costs 10. What focus would an Appliance Manufacturer use for their location decision? j. Cost focus (page 326 table 8.6) 11. When making a location at the site level, which of the following would be considered? k. Air, rail, trains, highway & waterway systems (p.435) 12. When considering the community attitudes, zoning restrictions, quality of labor force, are likely to be considered under which location decision method? l. Factor Rating