Version 1.0

Procedure to Install Parasoft Tool and Test KISU code

Pre-requisites:
Perform section ‘5) Installation of C++test and general setup for user’s accounts' from the document attached below (C++test_training_for_EntryNav-TEGRA_projects .pdf) to install Parasoft.

Creating an eclipse project to test your code using C++Test:

1. Open a new Terminal and perform the following steps: * export PATH=$HOME/parasoft/cpptest/9.4:$PATH ($HOME should be ‘/home/mmes/’) * Go to the source folder you want to test using C++Test and run: * "./build.sh C13384B 3.1.10" and then * "/home/mmes/parasoft/scripts/cpptest_make_bdf.sh make" (This should create the file 'cpptestscan.bdf' in the source folder.)

2. Open another terminal: * export PATH=$HOME/parasoft/cpptest/9.4:$PATH * export PATH=$PATH:/MM_BASE/arm/toolchain/toolchain/x86-linux2/bin * export PATH=$PATH:/bmw117/C13384B/sysroot/mm_entrynavc2hw-glibc_ivi_base/x86-linux2 (Modify the EntryNAV system release to the one in your setup, in this case it is ‘C13384B’) * Launch C++test GUI using “/home/mmes/parasoft/scripts/cpptest_gui.sh &”

3. To create the project: * Go to File > New... > Project > C/C++ > C++Project, then Next> * In the project definition dialog that appears do the following. Make sure to leave the “Use default location” checkbox enabled: * Give project name, e.g. kisu_try * In the project type select Makefile project > Empty project. * Press Finish. Do NOT switch to C/C++ perspective, if asked by Eclipse. ‘kisu_try’ node should appear in the Navigator tab.

4. Add the source folder (you want to test using C++Test) to the project you compiled in Step 1. For each folder perform the following: * Right click project node and select New ... > Other... > General > Folder * Make sure project folder is selected as a parent, and press Advanced >> button. * From the radio button select “Link to alternative location (Linked Folder)” and use Browse button to point to the folder with source tree to be tested. * Check if folder name is correct, and press Finish. A new folder should show up under project node.

5. Right click the project node and select Properties > Parasoft > C++test > Build settings. In the “Options source:” combo box select “Use options from a build data file”, and enter or use Browse button to point to location of ‘cpptestscan.bdf’ file created in step 1 above. Also, Use combo box for the compiler to select “gcc version 4.4.1 (Sourcery G++ Lite 2009q3-67)” and press Apply.

6. You should be ready to perform the tests. Now to perform the tests: * Right click on the project, -> Parasoft -> Test using -> Team > '[EN] Coding Rules v0.0 – TEGRA'.
This will start the static analysis. You can then generate the reports in pdf/html formats.

C++Test training document for EntryNav TEGRA: